From f0325a451f6ffbd3aa7e63833e0693b311f7abfd Mon Sep 17 00:00:00 2001 From: Nao Pross Date: Sun, 31 Oct 2021 20:49:44 +0100 Subject: Start doc on fading channels --- doc/thesis/figures/tikz/multipath-sketch.tex | 37 ++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) create mode 100644 doc/thesis/figures/tikz/multipath-sketch.tex (limited to 'doc/thesis/figures/tikz/multipath-sketch.tex') diff --git a/doc/thesis/figures/tikz/multipath-sketch.tex b/doc/thesis/figures/tikz/multipath-sketch.tex new file mode 100644 index 0000000..096f06f --- /dev/null +++ b/doc/thesis/figures/tikz/multipath-sketch.tex @@ -0,0 +1,37 @@ +% vim: set ts=2 sw=2 noet: +\begin{tikzpicture}[ + antenna/.pic = { + \draw[very thick] (0,0) -- ++(2mm, 3mm) -- ++(-4mm,0) -- cycle; + \draw[very thick] (0,0) -- ++(0,-5mm) coordinate (-mast) {}; + \draw[thick] (0,0) -- ++(0,3mm); + \node[inner sep = 0pt, outer sep = 6pt] (-center) at (0,2mm) {}; + }, + ] + + % Antennas + \draw (0,2) pic (T) {antenna} node[above left = 3mm] {\sffamily\bfseries TX}; + \draw (5,0) pic (R) {antenna} node[above right = 3mm] {\sffamily\bfseries RX}; + + % wall coefficients + \draw[thick] (4.75, 2.25) to[out = -20, in = 180] ++(1.2,-.5) node[right] {\(|\Gamma| > 0\)}; + + % walls + \draw[thick, fill = lightgray!20] (3,2) -- ++(2,-.5) -- ++(0,1) -- ++(-2,.5) -- cycle; + \draw[thick, fill = lightgray!20] (-1,0) -- ++(3,0) -- ++(1,-.5) -- ++(-3,0) -- cycle; + + + % reflected signals + \draw[line width = 2pt, blue!50!white, -latex] (T-center) -- node[above, pos = .5] {\(\tau_2\)} (4,2.25) -- (R-center); + \draw[line width = 2pt, blue!50!white, -latex] (T-center) -- node[left, pos = .7] {\(\tau_3\)} (1,-.25) -- (R-center); + \draw[line width = 2pt, blue!50!white, -latex] (T-center) -- node[above, pos = .5] {\(\tau_4\)} (-2.5,1.5) -- (R-center); + + % another wall + \draw[thick, fill = lightgray!20] (-2,0) -- ++(-1,.5) -- ++(0,2) --++(1,-.5) -- cycle; + + % LOS path + \draw[line width = 1mm, red!50!white, + decorate, decoration = { + expanding waves, angle = 5, segment length = 2mm + } + ] (T-center) -- node[above = 2mm, pos = .5] {\(\tau_1\)} (R-center); +\end{tikzpicture} -- cgit v1.2.1