From 1050ff24e003c748bccc41a28e16a1f5f04c290a Mon Sep 17 00:00:00 2001 From: sara Date: Fri, 17 Dec 2021 17:37:29 +0100 Subject: Doku --- doc/thesis/chapters/implementation.tex | 30 +++++++++++++++++++++++++++--- 1 file changed, 27 insertions(+), 3 deletions(-) (limited to 'doc') diff --git a/doc/thesis/chapters/implementation.tex b/doc/thesis/chapters/implementation.tex index abb7058..5b30b1d 100644 --- a/doc/thesis/chapters/implementation.tex +++ b/doc/thesis/chapters/implementation.tex @@ -394,16 +394,40 @@ An example of such a simulation plot is shown in \figref{fig:dynamic-exp}. When nothing mentioned the number of how many FIR- filter taps are used is eight. -%TODO: Other Plots -\subsubsection{Example from the skript} +%TODO: Other Plots? +\subsubsection{Real value example} %TODO: How to referenc Tabels feom an other Skript. +%TODO: Quelle https://www.etsi.org/deliver/etsi_ts/136100_136199/136104/11.04.00_60/ts_136104v110400p.pdf -To Do some realistic simulations with this block the examples from the script \cite{Mathis} are used. Withsh are standarized by ETSI (European Telecommunication Standards Institute). +In order to obtain a realistic simulation the values for multi-path fading propagation condition for a Extended Typical Urban (ETU) model from the ETSI (European Telecommunication Standards Institute) where used. This \skelpar[5]{ Simulate an example from the skript } +\begin{table}[b] + + \centering + \begin{tabular}{lll} + \toprule + Excess tap delay \([\mu s]\) & Relative power \([dB]\) & linear value for relative power \\ + \midrule + 0 & -1.0 & 0.7943282347242815 \\ + 50 & -1.0 & 0.7943282347242815 \\ + 120 & -1.0 & 0.7943282347242815 \\ + 200 & 0.0 & 1.0 \\ + 230 & 0.0 & 1.0 \\ + 500 & 0.0 & 1.0 \\ + 1600 & -3.0 & 0.5011872336272722 \\ + 2300 & -5.0 & 0.31622776601683794 \\ + 5000 & -7.0 & 0.19952623149688797 \\ + + \bottomrule + \end{tabular} + \caption{Values used for the simulation\label{tab:values}} +\end{table} + + \subsection{Measurements} -- cgit v1.2.1