aboutsummaryrefslogtreecommitdiffstats
path: root/doc/thesis/chapters
diff options
context:
space:
mode:
Diffstat (limited to 'doc/thesis/chapters')
-rw-r--r--doc/thesis/chapters/implementation.tex18
-rw-r--r--doc/thesis/chapters/theory.tex2
2 files changed, 14 insertions, 6 deletions
diff --git a/doc/thesis/chapters/implementation.tex b/doc/thesis/chapters/implementation.tex
index ff073ee..9a20d24 100644
--- a/doc/thesis/chapters/implementation.tex
+++ b/doc/thesis/chapters/implementation.tex
@@ -341,10 +341,21 @@ Rician fading factor K = 0 = Rylehnt Model
\subsection{Measurements}
+\skelpar[5]{
+ Do some masurements
+}
+
\subsection{Empirical BER} \label{sec:ber}
-To find out how accurate the simulations are comparer with a simulation of the fadinng effect and test measurements, the byte error rate of the system is calculated. This is done with the help of a user specified \(k\)-byte test frame in the beginning of each vector. Implemented according to the code in \ref{lst:ber-block}. Every bit is compared with the test vector at the beginning before the modulation and demodulation part.
-Because of the fact that the test vector has some random bit at the end the bit error rate has always a value on average 32.
+To find out how accurate the simulations are comparer with a simulation of the fadinng effect and tested measurements, the byte error rate of the system is calculated. This is done with the help of a user specified \(k\)-byte test frame in the beginning of each vector. Implemented according to the code in \ref{lst:ber-block}. Every bit is compared with the test vector at the beginning before the modulation and demodulation part.
+Because of the fact that the test vector has some random bit at the end the bit error rate has always a value on average 32, even when its perfect match. So to avoid high numbers this value is subtracted and only on focused on the positive values.
+
+The vector which is used as test vector is: \([0x1f, 0x35] + [0x12, 0x48] \), because this numbers are well suited to compare.
+For generating the Byte error rate it is focus on byte-blocks of a specific length. So for each of this blocks compared with test vector there is a BER. To make it simpler or better said to avoid mistakes, the last 200 of this individual BER are taken to find an average and the highest value.
+
+\skelpar[5]{
+ Maybe more
+}
@@ -380,9 +391,6 @@ Because of the fact that the test vector has some random bit at the end the bit
-\skelpar[5]{
- Discuss how i did that
-}
\begin{figure}
diff --git a/doc/thesis/chapters/theory.tex b/doc/thesis/chapters/theory.tex
index 207912b..6255648 100644
--- a/doc/thesis/chapters/theory.tex
+++ b/doc/thesis/chapters/theory.tex
@@ -350,7 +350,7 @@ for some parameter \(\sigma\). Loosely speaking, the distribution needs to be ``
\end{subfigure}
\hskip 5mm
\begin{subfigure}{.45\linewidth}
- \skelfig
+ \skelfig
\caption{LOS, Rice}
\end{subfigure}
\caption{