Add datasheets and resources

1 files changed, 59 insertions, 0 deletions

diff --git a/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT b/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT
new file mode 100644
index 0000000..061965f
--- /dev/null
+++ b/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT
@@ -0,0 +1,59 @@
+------------------------------------------------------------------
+STOP! If you are upgrading from v2 you must install the v4 bootloader first:
+http://dangerousprototypes.com/2010/01/18/how-to-bus-pirate-bootloader-v4-upgrade/
+v4 BOOTLOADER ONLY!!!
+DO NOT TRY TO LOAD THE BOOTLOADER FROM THIS ARCHIVE!!!! 
+DO NOT TRY TO LOAD THE V4 FIRMWARE WITH p24QP!!!
+------------------------------------------------------------------
+Firmware upgrades:
+
+http://dangerousprototypes.com/docs/Bus_Pirate#Firmware_upgrades
+
+1) Enter the bootloader:
+
+Connect PGC and PGD pins of the ICSP header and plug in the USB cable
+
+--+OR+--
+
+Type $ in the Bus Pirate terminal.
+
+With both methods the MODE LED should light.
+
+2) Load the new firmware:
+
+* ds30Loader: just use the GUI (.net/Mono required)
+* Pirate-loader (console app for Windows, Linux, Mac) firmware upgrades:
+
+C:\pl>pirate-loader --dev=COM10 --hex=BPv3-Firmware-v1.0.hex
+
+3) re-plug the USB cable to reset the Bus Pirate. The upgrade is complete.
+
+------------------------------------------------------------------
+BPv3-Bootloader-v4.4.hex is the same as v4.3 installed with the updater. This file is only for programming the bootlaoder to a new PIC. Use the upgrade package to upgrade:
+
+http://dangerousprototypes.com/docs/Bus_Pirate#Bootloader_upgrades
+
+------------------------------------------------------------------
+vX-Firmware-vY(.z_Z).hex
+
+Normal Bus Pirate firmware.
+vX - Bus Pirate hardware version.
+vY - The Bus Pirate firmware version.
+z_Z - The .z_Z versions are translated compiles (currently Spanish and Italian).
+
+vX-STK500v2-vY(-hiz).hex
+
+ATMEL AVR programmer clone for the Bus Pirate hardware. An STK500 v2 protocol compatible firmware for the Bus Pirate, works with AVRDude, AVR Studio v4.11+, etc.
+vX - Bus Pirate hardware version (v2go and v3 use the same firmware).
+vY - THe STK500v2 clone firmware version.
+hiz - The -hiz version of the fimware uses open drain/high impedance outputs. On-board pull-up resistors are enabled (where applicable). The non -hiz version uses normal 3.3volt outputs.
+
+vX-PIC Bootloader-vY.hex
+
+Bootloader to program in a new PIC microcontroller. This is usually only programmed once.
+vX - Bus Pirate hardware version.
+vY - The Bus Pirate bootloader version.
+
+BPvX-Firmware-vX.X-extras.hex
+
+The BPv3-Firmware-vX.X-extras.hex has a few modes and new stuff we couldn't fit in the main firmware.