1 files changed, 0 insertions, 59 deletions
diff --git a/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT b/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT
deleted file mode 100644
index 061965f..0000000
--- a/res/buspirate/v3/firmware/BusPirate.firmware.v5.10/BPv1a/README.TXT
+++ /dev/null
@@ -1,59 +0,0 @@
-------------------------------------------------------------------
-STOP! If you are upgrading from v2 you must install the v4 bootloader first:
-http://dangerousprototypes.com/2010/01/18/how-to-bus-pirate-bootloader-v4-upgrade/
-v4 BOOTLOADER ONLY!!!
-DO NOT TRY TO LOAD THE BOOTLOADER FROM THIS ARCHIVE!!!! 
-DO NOT TRY TO LOAD THE V4 FIRMWARE WITH p24QP!!!
-------------------------------------------------------------------
-Firmware upgrades:
-
-http://dangerousprototypes.com/docs/Bus_Pirate#Firmware_upgrades
-
-1) Enter the bootloader:
-
-Connect PGC and PGD pins of the ICSP header and plug in the USB cable
-
---+OR+--
-
-Type $ in the Bus Pirate terminal.
-
-With both methods the MODE LED should light.
-
-2) Load the new firmware:
-
-* ds30Loader: just use the GUI (.net/Mono required)
-* Pirate-loader (console app for Windows, Linux, Mac) firmware upgrades:
-
-C:\pl>pirate-loader --dev=COM10 --hex=BPv3-Firmware-v1.0.hex
-
-3) re-plug the USB cable to reset the Bus Pirate. The upgrade is complete.
-
-------------------------------------------------------------------
-BPv3-Bootloader-v4.4.hex is the same as v4.3 installed with the updater. This file is only for programming the bootlaoder to a new PIC. Use the upgrade package to upgrade:
-
-http://dangerousprototypes.com/docs/Bus_Pirate#Bootloader_upgrades
-
-------------------------------------------------------------------
-vX-Firmware-vY(.z_Z).hex
-
-Normal Bus Pirate firmware.
-vX - Bus Pirate hardware version.
-vY - The Bus Pirate firmware version.
-z_Z - The .z_Z versions are translated compiles (currently Spanish and Italian).
-
-vX-STK500v2-vY(-hiz).hex
-
-ATMEL AVR programmer clone for the Bus Pirate hardware. An STK500 v2 protocol compatible firmware for the Bus Pirate, works with AVRDude, AVR Studio v4.11+, etc.
-vX - Bus Pirate hardware version (v2go and v3 use the same firmware).
-vY - THe STK500v2 clone firmware version.
-hiz - The -hiz version of the fimware uses open drain/high impedance outputs. On-board pull-up resistors are enabled (where applicable). The non -hiz version uses normal 3.3volt outputs.
-
-vX-PIC Bootloader-vY.hex
-
-Bootloader to program in a new PIC microcontroller. This is usually only programmed once.
-vX - Bus Pirate hardware version.
-vY - The Bus Pirate bootloader version.
-
-BPvX-Firmware-vX.X-extras.hex
-
-The BPv3-Firmware-vX.X-extras.hex has a few modes and new stuff we couldn't fit in the main firmware.